Table of Contents
Advertisement
(Continued)
Q
STEP 3 6: Areas o f the seal raised
off
the
I
STEP 5 B: Before installing the
cleaner blade should be less than 3 inches
@
photoreceptor drum assembly, refer to
Q
STEP 2
tl:
Ensure that the seal stays
(76 mm) long and 31 16 inches (4 mm)
section 6 , Photoreceptor Maintenance
against the side of the xerographic
high. There should be no raised areas
and perform the Photoreceptor Cleaning
module.
within 12 inches (300 mm) from either
Enhancement.
end o f the cleaner blade.
2.
(Figure
3):
Install the Contarnination
5.
Reinstall the following:
Seal.
a. Charge CorotronlErase
amp
(REP
3.
(Figure 4): Check the seal for correct
9.8)
OD
A
installation.
b. Photoreceptor Drum (REP 9.3)
ALIGN THE EDGE
c.
Xerographic Module
(REP 9.1)
OF THE SEAL WITH
INCHES
4. Remove any rasied areas by moving your
d.
Right
and
Left Side Doors (REP 14.1
THE
EDGE
OF
THE
finger across
the
top of the seal
and push
the raised area to either
end
of the Cleaner
Blade Assembly.
INSTALL THE
CLEANER BLADE
ASSEMBLY INSIDE
Figure 3. Install the Contaminatlon Seal
Figure 4. Check for correct installation
3/93
REP 9.14
4-96
3050
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Chapters
Table of Contents
