Xerox 3050 Service Manual page 652

(Continued)
6.
Clean the entire cleaner blade area with
a
vacuum cleaner.
7. Clean the Cleaner Blade with film remover
and put a light coating of zinc stearate on
the Cleaner Blade.
Q
Do not reinstall the toner waste bottle
on the xerographic module.
8. Reinstall the following:
a. Reinstall the Cleaner Blade (REP
9.4)
b.
Cleaner Blade Assembly
c. Photoreceptor Drum Assembly
d. Xerographic Module
9. (Figure 2): Remove the Control Console.
B
REMOVE THE WIRE
HARNESS FROM THE
DISCONNECT
Figure
2.
Remove the Control Console
101696
(Continued)
lot92
Removal
6-50
3050