Xerox 3050 Service Manual page 639

(Continued)
SrEP24 B: To ensure a safe position of
Q
The xerographic module may remain on
the xerographic module on the service
the service rails to instal/ the
23. (Figure 22): Remove tlie Fuser Drive 8elt. raNs, the pins on the module must be in
photoreceptor,
the slots on the rails. The module is
heavy and it is difficult to handle.
24. (Figure 23): Remove
the Xerographic
Module.
A
REMOVE THE
BELT
FROM THE
DRIVE PULLEY
Figure 22. Remove the Foser Drive Belt
'
PULL THE XEROGRAPHIC
MODULE O N T O THE
SERVICE RAIL5
8'
ENSURE THAT THE PIN ON
THE XEROGRAPHIC
MODULE IS LOCATED IN
THE SLOT ON THE
SUPPORTS (2) BOTH ENDS
01617
Figure
23.
Remove the Xerographic Module
(Continued)
1 O/O2
3050 6-37
Installation