Xerox 3050 Service Manual page 437

(Continued)
STEP 12 6: To avoiddamage to the
flanges on the sides o f the idler pulley if
the latching cover is lowered, raise the
idler fully
up
as shown in Figure
7.
12.
(Figure 8): Remove the Fuser Drive Belt.
IDLER PULLEY
FULLY UP
Q
C
TIGHTEN THE ~ U T
d
DRIVE PULLEY
Figure
8.
Remove the Fuser Drlve Belt
WARNING:
The fuser may be hot
Cover the photoreceptor drum with a
light shield to prevent damage.
STEP 12 8: Be
careful when removing
the module, The module is heavy and
i t
i s
difficult to handle.
Q the xerographic module may remain
on the service rails for some of the
repair procedures. It may also be
removed to a flat, clean surface for
service or storage,
13. (Figure 9): Remove the Xerographic
Module t o clean, flat surface if not being
serviced on the service rails.
14.
Continue with Step 15
if the service i s
being performed on the service rails.
ONTO THE SERVICE
RAILS
B w
LIFT THE XEROGRAPHIC
MODULE BY THE
HANDLES TO REMOVE IT
Figure 9. Remove the Xerographic Module t o a Clean Flat Surface
(Continued)
4/96
3050 4-63
REP 9.1A