Xerox 3050 Service Manual page 494

1
2. (Figures
6
and 7): Complete the
installation of the Heat Rod.
P
REINSTALL THE
POSITION SUPPORT BRACKET
BRACKET AND
WlTH SLOTS (2) ALIGNED WlTH
SECURE SCREWS (2)
FRAME SCREW
HOLES (2)
WlRE WITH
TWIST TIE
D .
- 7 . v .
..-
REINSTALL BLADE WEIGHT
I
AND TIGHTEN SETSCREW
C
SECURE WIRE
REINSTALL THE
I.
Reinstall the following:
a. Oil Dispense Assembly
(REP 10.7).
b. Stripper Finger Assembly (REP 10.6).
c. Xerographic Module (REP 9.1).
d. Right and Left Side Door (REP 14.1).
D
By heating the fuser roll to the
operating temperature
and
allowing
it to run, fuser
oil will
be evenly
applied to the surface of the fuser
roll.
1 . Enter the Diagnostic Mode.
WARNING
Chere will be a time delay between the
tlme the code 11003-11 is entered and the
tlme the Main Drive Motor is energized.
The
Drive Motor will not start until the
Fuser Heet Roll is at the correct operating
temperature.
Enter the code 11003-1). Allow the
Main Drive Motor to cycle. When the
Drive Motor stops, exit the Diagnostic
Mode.
Ensure that the Thermistor is clean and
is in contact with the Fuser Heat Roll
after reassembly.
6
CONNECT HEAT
ROD RED CONNECTORS
W520
1
I
Flgure 7. Completing the lnstallatlon
I
4/96
REP 10.1 8
4-1000 3050