Xerox 3050 Service Manual page 620

Specifications
Product Codes Magnification Audible Noise: 67 db (A) or less.
The product code is located on the serial 1:1 nominal (f l/2%) with 20
Ib
(75 gsm)
number plate and identifies the product bond and test pattern 82E5980.
configuration.
60 Hz 14P Cut Squareness
50Hz OK4
The cut length of the copy will be square
Physical Characteristics
within k 0.4 % of the copy width. The edge
will not vary from a straight line more than
Weight 6 19 pounds 281.4 kg 0.040 inch (Imm).
Depth 27 inches 68.6 cm
Width 57 inches 144.8 cm Electrical Power Requirements
Height 58 inches 147'3 cm
USOIXCI: The power outlet must be on a 20
Document (Original) Size
Minimum Size: (USO) 8.5 inches (216 mm)
wide
X
11 (280 mm) long;
(RX)
210 mm wide
X
297 mm long
(A4).
Maximum Size: (USO) 36 inches (914 mm)
wide X 82 feet (25 meters) long; (RX) 841
mm wide
X 25
meters long. Note: Any
Document greater than 60 inches (152.4 cm)
in length must be run in the Sets Mode of
Operation.
Installation Space Required
ampere line that i s dedicated (wired directly
to the circuit breaker panel with no shared
Side Edge
105 inches (267 cm) X 87 inches (221 cm) neutral and on a different ~ h a s e from the
lighting circuit, in order to pievent dimming For all modes, copy misalignment is 6 mm to
Copy Rate the lights). the machine center (media location) for
-
.
-
First copy out: 20 seconds 60 Hz: 104-127 VAC, 60
Hz,
single phase
I
copies 1-10. The recommended maximum
multiple copy job is 15 copies.
The
Three inches per second
metres per
50 Hz: ~2()/240 VAC, 50 Hz, single phase
minute)
maximum number of copies that can be
Current at 1 15 VAC:
selected i s limited to 15.
Maximum Number of Copies Selected Standby (Power Saver): 6 amperes
M u l t i ~ l e Mode:
Running: 16 amperes
Vh
0 Tag/ MOD 16: 99 Copies
WI Tag/ MOD 16: 15 Copies
Sets Mode: one Copy
Cut Length Accuracy
Current at 230 VAC:
Standby (Low Power): 2 amperes
Running: 6 amperes
Power Consumption:
Standby (Power Saver1 Low Power):
Copies up to 24 inches (610 mm), will be cut 690 watts
within f 118 inch (4.5 mm). For lengths
greater than 24 inches (610 mm), any copy Running: 1840 watts (60 Hz);
will be within
f
0.5
%
of the specified copy 1400 watts (50
Hz)
length. From the first copy to the last copy
of a multiple copy run,the difference in Power cord length: 10 Feet (3 metres)
length will be no more than 5/32 inch (6
mm).
Specifications