Xerox 3050 Service Manual page 651

Removal Procedure
If the installation becomes an abort, or if the
3050 must be moved t o
a
different location
and repacked, the following procedures will
be necessary.
1.
Warning: Disconnect the power cord.
2.
Remove the Xerographic Module (REP
9.1).
To prevent damaging the
the 3050 must be
cleaning blade not
touching the photoreceptor.
3. (Figure 1): Install a tie-wrap on the
Cleaning Blade Solenoid Weight.
4, Remove the Photoreceptor Drum
Assembly
(REP 9.2).
5. Remove the Cleaner Blade (REP 9.4).
Figure 1 . Install a Tie-Wrap on the Cleaning
Blade Solenoid Weight
(Continued)
Removal