Xerox 3050 Service Manual page 507

WARNING
Wear protective gloves when handling the
parts with fuser oil on them. Use caution
and do not allow the fuser oil to contact
your eyes. Fuser oil can cause severe eye
irritation. Wash hands after handling any
components that are covered with fuser oil.
A
WARNING
Use extreme caution when working in the
fuser area and do not touch any heated
components. The fuser roll WlLL be hot.
Ensure that the area where components
with fuser oil is present is protected by a
drop cloth. Clean any fuser oil spills with
warm water and soap to avoid the
possibility of bodily injury due to falls.
3.
Connect the Power Cord and enter
diagnostics.
4. Lower the Cut Sheet Feed-in shelf, and
place a magnet on the Cut Sheet Feed-in
Shelf lnterlock Switch.
5. Enter the code [O9 21 41 and wait for the
Fuser roll to warm to run temperature.
0
If 109 21
41
times out while
performing the oiling process,
re-
enter the code 109
2 1 41
and
continue.
6. Apply part of an 8cc tube of fuser oil
(93E00811) to a folded soft cloth.
7.
Wipe the fuser oil soaked cloth evenly
across the entire surface of the Fuser
Rol I.
8.
Repeat steps 6 and
7
until the entire
contents of the tube of oil is used.
Q
Dry
areas appear
as
dull spots, as
opposed to oiled areas that appear
as glossy
areas.
9. Inspect for dry and/or contaminated
areas on the Fuser Roll. If dry or
contaminated areas are found, wipe the
pad with oil back and forth across the
area while applying pressure.
10. Press the Stop button two times.
1 1. Wipe the Fabric Guide with the same
cloth to remove any
excess
oil and debris
that may be present.
12. Clean the Fabric Guide with a clean dry
pad.
13. Reinstall the following:
a. Oil Dispense Assembly (REP 10.7)
b. Stripper Finger Assembly (REP 10.6)
14.
Remove the magnet from the Cut Sheet
Feed-in Shelf lnterlock Switch and raise
the Cut Sheet Feed-in Shelf.
15. Perform the Fuser Temperature
Adjustment (ADJ 10.1).
16. Exit diagnostics and select a quantity of 6 to
make
6
copies of the blank side of the test
, pattern (82E5980) (all white) to remove any
excess oil from the Fuser Roll surface.
WARNING
Use extreme caution when working in the
fuser area and do not touch any heated
components. The Stripper Finger Assembly
WlLL be hot.
17.
Use a thick soft clean cloth to wipe any
excess Fuser Oil from the ends of the Fuser
Roll and the Fabric Guide.
REP 10.9