Xerox 3050 Service Manual page 423

(Continued)
Replacement
7.
(Figure
2):
Remove the Media Transport
Drive Motor from the Mounting Plate.
A
REMOVE THE GROUND
SCREW AND WlRE
"
REMOVE THE RETAINER
1. The replacement is the reverse of the
removal
Q
For Replacement of the Media Transport
Drive Motor, refer to Figure 1 of the
Removal: Ensure that the belt is over the
idler pulley, as shown in the Figure 1.
Q If
a new motor is being installed, install
the gear on the new motor.
AND THE GEAR
C
REMOVE THE SCREWS AND
WASHERS (3 PLACES)
d
I
1
02019
1iiqq-q-1
Figure
2.
Remove the Media Transport Drive Motor from the mounting plate