Xerox 3050 Service Manual page 171

OF 4 Component Failure with
No
Status
Code RAP
This RAP is used for problems that are not
indicated by a status code.
The problem may occur i f there is a problem
with the copier sensors, control logic,
mechanical components, the drive motors,
the motor control circuitry or poor quality
documents.
Initial Actions
If the Document will not scan, go to
the OF2 Document Does Not Scan
RAP.
If the Media will not feed,
go
to the
OF3 Media Does Not Feed RAP.
If the Control Panel displays the
message, "REFEED ROLL
1
or 2 or 3",
go to one of the following RAPS:
-
Refeed Roll 1 RAP,
-
Refeed Roll
2
RAP,
-
Refeed Roll 3 RAP
If the Control Panel displays the
message, "NVM Fault
Call for
Assistance
",
go to the NVM
Fault Call
for Assistance RAP.
If the Control Panel displays only the
number 2, 3,4, 5,6 or 7, go to the 2.2
POST 2,3,4,5,6 and 7 RAP.
Procedure
Refer to Table 1 and locate the comoonent
that
is
not functioning in the
COMPONENT
column. Perform the reauired action listed
I
COMPONENT
in the corresponding GO TO column.
TABLE 1
I I
Drum/ Developer
Drive Motor (MOT21)
I
Fuser Drive Motor
(MOT22)
Cleaner Blade
Solenoid (SOL3)
Media Transport
Drive Motor
(MOT1)
4.1 Drum/ Developer
Drive Motor (W/O
TagMOD 28) RAP
4.2 Fuser Drive
Motor(WI0 TagMOD
28) RAP
C Q 15 Residual
Image (Section 3)
8.1
Media Transport
RAP
I
Roll Drive Motor
(MOT1)
7.1 Roll 1 Feed RAP
Document Drive
I
Motor (MOT23)
- - -
5.1 Document
Handler RAP
1
Cooling Fans
1.3 Cooling Fans RAP
Toner Cartridge
Drive Motor (M4)
J2.02 Toner
Cartridge Home
Position RAP
Cutter Drive Motor
I
(MOT11
C O . O 1 Media Cut RAP
4.3 Main Drive Motor
W/O Tag /MOD 28
RAP
- -
4196
2-213
OF 4 Copier Failure with No Status Code RAP