Xerox 3050 Service Manual page 301

Damaged Media
RAP(Continued)
Probable Cause
Corrective Action
6.
Tears In the Media Lead Edge
6.
Damaged Stripper Finger.
Media side-to-side registration.
7.
Wrinkle
7.
A severe case of creases that runs in the
direction of the media travel.
This i s damage that i s probably caused
by the fuser subsystem.
8. Cockle 8.
The media has a rough surface like an
orange peel.
This damage could be caused by the
fuser subsystem.
9.
Other Damage
Damage or obstruction in the handling 7.
system for the media.
Fuser
i s
too hot.
Damp media.
Fuser Pressure Plates or Fabric Guide
( PL
10.3) is damaged or incorrectly installed.
Tightly rolled media.
Fuser Heat Roll
is
damaged or
contaminated.
Damage or obstruction in the handling
8.
system for the media.
Fuser i s too hot.
Damp media.
Fuser Pressure Plates or Fabric Guide (PL
10.3) is damaged or incorrectly installed.
Replace the Stripper Finger
(PL
10.4).
Reposition the media roll on the Roll
Support Tube.
Check for an obstruction in the area of the
transfertdetack corotron.
'
Check for an obstruction or damaged
guides in the media area.
Check the media path for an obstruction
or damage.
CheckIAdjust the Fuser Temperature (ADJ
10.1)
Try a new media roll or
a
cut sheet.
Replace the Fuser Roll (PL 10.2).
Replace Pressure Plates.
Check the media path for an obstruction
or damage.
ChecWAdjust the Fuser Temperature (ADJ
10.1)
Try a new media roll or a cut sheet.
Tightly rolled media.
9. If there are other defects that are on the
copy, go to the Media Handling Problems
on the following pages.
Damaged Media RAP