Xerox 3050 Service Manual page 493

Replacement
LEFT END VIEW
CAUTION
STEP 1
B:
Wear gloves or wra a
sheet of pa er around the Heat
1
od
when han&ng the Rod. Oil from
your fingers can damage the Heat
Rod.
1.
(Figure 5): Install the Heat Rod.
STEP 1 A:
lnstall the Heat Rod, RED
connector first.
DO NOT
remove the
connectors from the wires on the
ends of the heat rod, The heating
element inside the rod is closer to the
end with the white connector.
STEP 1
A: lnsert the red connector
into the Heat Roll, while looking into
the Roll. Align the red connector
with the hole in the Fuser Drive Gear
and insert the connector through the
gear. If the connector will not go
through, use the rod that secures the
fabric guide. lnsert the rod through
the right side of the xerographic
module. Secure the red connector to
the rod and pull the heat rod into
the fuser roll.
SERT CONNECTOR
TO THE BEARING
PUSH PIN IN WHILE
DOING THE STEP
C
INSTALL BEARING AND
ENSURE THAT THE PIN IS
.
. .
SEATED IN HOLE FULLY
41 96
3050 4-IOOC
REP 10.1 B