Xerographics; Rep 9.1A Xerographic Module (W/ 0 Tag/ Mod 28) - Xerox 3050 Service Manual

REP 9.1 A Xerographic Module
(W/ 0 Tag/ MOD 28)
Parts List on PL 9.1
Note: Some copiers are equipped with TWO
AC Drive Motors, Developer Drive Motor (MOT
21), and Fused Drum Drive Motor (MOT22).
Copiers equipped with TWO AC Drive Motors
are identified as Without Tag / MOD 28, (W I 0
Tag 1 MOD 28).
Other copiers are equipped with ONE AC Drive
Motor, Main Drive Motor (MOT21). Copiers
equipped with ONE AC Drive Motor are
identified
as With fag
I MOD 2 8 , (W I Tag /
MOD 28).
Use
this procedure on copiers equipped with
TWO AC
Drive Motors,
(WI 0 Tag /
MOD
28).
On copiers equipped with ONE
AC
Drive
Motor, refer to the (REP
9-18
Xerographic
Module (Wl Tag/ MOD 28) removal procedure.
Removal
1. Switch off the Main Power Switch.
Disconnect the Power Cord.
2. Lift and rotate the Control Console.
3. Remove the Document Handler.
4. Remove
the Right and Left Side Doors (REP
14.1).
5. (Figure 1): Lift the Document Feed-in Shelf.
ROTATE 114 TURN
SCREWS (2) ONE
EACH END
Figure 1. Lift the Document Feed-in Shelf
1 - 1
(Continued)
4196
REP 9.1A
4-58 3050