Xerox 3050 Service Manual page 648

(Continued)
DO
NOlrun copies prior to performing
@
the lnitid Density Adjustment section
of the Electrostatic Series (ADJ 9.2).
Running copies prior to this adjustment
may cause toner faults andlor
premature copy quality defects.
(Figure 34): Switch the copier on and
enter the diagnostic mode.
Perform ONLY the Initial Density
Adjustment Section of the Electrostatic
Series (AD1 9.2). The total Electrostatic
Series will be performed later in this
procedure.
Refer to the Service Manual and perform
the following adjustments:
a. Country Configuration (ADJ 3.2)
b.
Cleaner Blade Solenoid (ADJ 9.1)
c. Electrostatic Series (ADJ 9.2)
d. Fuser Temperature (ADJ 10.1)
e. Copy Size Adjustment (ADJ 5.1)
f. Image Registration (ADJ
8.1)
(Part
of ADJ 5.1)
g. Auto Cut Length (ADJ 8.2) (Part of
ADJ 5.1)
Exit the diagnostic mode.
10. Inform the operator that the following
adjustments are operator adjustments and
can be changed to fit their needs. Refer to
the User Guide and perform the following
adjustments:
a. Feature Timeout
b. Power Saver Mode (RX: Low Power
Mode)
c.
Standby Mode
d.
Lead Edge Margin
e. Trail Edge Margin
SWITCH THE COPIER
ON
(Continued)
8/94
Installation
6-46
3050
Figure 34. Switch the Copier on
A
01636
TAR SM6 M