Xerox 3050 Service Manual page 457

REP 9.38 Photoreceptor Drum
(WI Tag/ MOD 27)
Parts List on PL 9.2 B
Note: Some copiers are equipped with a
Wing Nut located on the end of the Drum
Shaft. The Wing Nut is identified as Tag1
MOO 27. Copiers equipped with
a
Wing Nut
are
identified as
Wlth Tag I
MOO 27, (W
I Tag
I MOO 27).
Copiers not equipped with a Wing Nut ere
identified as Without Tag I MOD
27,
(W I 0
Tag l MOD 27).
Use this procedure on copiers equipped with
a Wing Nut, (W I Tag/ MOD 27).
On copiers not equipped with a Wing nut,
refer t o the (REP 9.3A Photoreceptor Drum
WI 0 Tag1 MOD 27) removal procedure.
Removal
WARNING
Switch
off
the Main Power Switch.
Disconnect the Power Cord.
Remove the
Right and the Left Side
Doors.
Remove the Xerographic
Module
(REP
9.1).
Remove
the
Photoreceptor Drum
Assembly (REP 9.2).
(Figure 1): Remove the Photoreceptor
Drum.
REMOVE THE
REMOVE BEARING,
SPROCKET AND PLATE
REMOVE
WING NUT
I
Apure
1. Removal of the Photoreceptor
Shift
Assembly
4196
3050 4*70A
REP 9.3 B