Reset - D-Link DGS-3130 Series Web Ui Reference Manual

DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Parameter
IPv6 Address
Domain Name
Initial TTL
Max TTL
Port
Timeout
Length
Source IPv6 Address
Probe Number
Click the Start button to initiate the route trace for each individual section.
After clicking the Start button in IPv4 Trace Route section, the following IPv4 Trace Route Result section will
appear:
Click the Back button to stop the trace route and return to the IPv4 Trace Route section.

Reset

This window is used to reset the Switch's configuration to the factory default settings.
To view the following window, click Tools > Reset, as shown below:
Select one of the following options:
• The Switch will reset to its factory default settings and then reboot.
• The Switch will reset to its factory default settings and then reboot. This option excludes the IP address.
Description
Select and enter the IPv6 address of the destination here.
Select and enter the domain name of the destination here.
Enter the initial Time-To-Live (TTL) value here. The range is from 1 to 255.
Enter the Time-To-Live (TTL) value of the trace route request here. This is the
maximum number of routers that a trace route packet can pass. The trace route
option will cross while seeking the network path between two devices. The
range for the TTL is 1 to 255 hops.
Enter the port number here. The value range is from 1 to 65535.
Enter the timeout period while waiting for a response from the remote device
here. A value of 1 to 65535 seconds can be specified. The default is 5 seconds.
Enter the length value here. This specifies the number of bytes of the outgoing
datagram. The range is from 1 to 1420 bytes.
Enter the source IPv6 address here. The specified IPv6 address must one of
the IPv6 addresses configured for the Switch.
Enter the probe time number here. The range is from 1 to 1000. If unspecified,
the default value is 1.
Figure 13-16 Trace Route (Start) Window
Figure 13-17 Reset Window
433