Network Monitoring Commands - D-Link xStack DGS-3426 Cli Manual

The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
show packet ports
show error ports
show utilization
clear counters
clear log
show log
enable syslog
disable syslog
create syslog host
config syslog host
config syslog host all
delete syslog host
show syslog host
show syslog
config system_severity
show system_severity
Each command is listed, in detail, in the following sections.
show packet ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the packets analysis for port 7:
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Parameters
<portlist>
<portlist>
[ports | cpu]
{ports <portlist>}
index <value_list>
<index 1-4> {severity [informational | warning | all] | facility [local0 |
local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number>| ipaddress <ipaddr> | state [enable | disable]}
{severity [informational | warning | all] | facility [local0 | local1 |
local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number> | ipaddress <ipaddr> | state [enable |
disable]}
{severity [informational | warning | all] | facility [local0 | local1 |
local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number> | state [enable | disable]}
[<index 1-4> | all]
{<index 1-4>}
[trap | log | all] [critical | warning | information]
Used to display statistics about the packets sent and received by the
Switch.
show packet ports <portlist>
This command is used to display statistics about packets sent and
received by ports specified in the <portlist>.
<portlist> − Specifies a port or range of ports to be displayed.
None.
N M
ETWORK
54
C
ONITORING
9
OMMANDS