D-Link xStack DGS-3426 Cli Manual page 77

delete stp instance_id
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete STP instance ID 2 from the Switch.
DGS-3400:4#delete stp instance_id 2
Command: delete stp instance_id 2
Success.
DGS-3400:4#
config stp priority
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set the priority value for instance_id 2 as 4096:
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Used to delete a STP instance ID from the Switch.
delete stp instance_id <value 1-15>
This command allows the user to delete a previously configured
STP instance ID from the Switch.
<value 1-15> - Enter a value between 1 and 15 to identify the
Spanning Tree instance on the Switch.
Only administrator-level users can issue this command.
Used to update the STP instance configuration
config stp priority <value 0-61440> instance_id <value 0-15>
This command is used to update the STP instance configuration settings
on the Switch. The MSTP will utilize the priority in selecting the root bridge,
root port and designated port. Assigning higher priorities to STP regions
will instruct the Switch to give precedence to the selected instance_id for
forwarding packets. The lower the priority value set, the higher the priority.
priority <value 0-61440> - Select a value between 0 and 61440 to specify
the priority for a specified instance id for forwarding packets. The lower the
value, the higher the priority. This entry must be divisible by 4096.
instance_id <value 0-15> - Enter the value corresponding to the previously
configured instance id of which the user wishes to set the priority value. An
instance id of 0 denotes the default instance_id (CIST) internally set on the
Switch.
Only administrator-level users can issue this command.
DGS-3400:4#config stp priority 4096 instance_id 2
Command : config stp priority 4096 instance_id 2
Success.
DGS-3400:4#
74