D-Link xStack DGS-3426 Cli Manual page 219

config ssh user
Restrictions
Example usage:
To configure the SSH user:
DGS-3400:4# config ssh user Trinity authmode Password
Command: config ssh user Trinity authmode Password
Enter a case sensitive new password: *******
Enter the new password again for conformation:*******
Success.
DGS-3400:4#
show ssh user authmode
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the SSH user:
DGS-3400:4#show ssh user authmode
Command: show ssh user authmode
Current Accounts:
UserName
--------------
Trinity
DGS-3400:4#
Note: To configure the SSH user, the administrator must create a user account on the
Switch. For information concerning configuring a user account, please see the section of
this manual entitled Basic Switch Commands and then the command, create account
user.
config ssh algorithm
Purpose
Syntax
Description
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
password, and then to retype the password for confirmation.
publickey – This parameter should be chosen if the user wishes to
use the publickey on a SSH server for authentication.
Only administrator-level users can issue this command.
Used to display the SSH user setting.
show ssh user authmode
This command allows you to display the current SSH user setting.
None.
None.
Authentication
---------------------
Hostbased
Used to configure the SSH algorithm.
config ssh algorithm [3DES | AES128 | AES192 | AES256 | arcfour |
blowfish | cast128 | twofish128 | twofish192 | twofish256 | MD5 |
SHA1 | RSA | DSA] [enable | disable]
This command allows you to configure the desired type of SSH
algorithm used for authentication encryption.
Host Name Host IP
----------------- ---------
12334 10.45.25.8
216