D-Link xStack DGS-3426 Cli Manual page 68

delete syslog host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete a previously configured syslog host:
DGS-3400:4#delete syslog host 4
Command: delete syslog host 4
Success.
DGS-3400:4#
show syslog host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show syslog host information:
DGS-3400:4#show syslog host
Command: show syslog host
Syslog Global State: Disabled
Host Id Host IP Address
-------
1
2
3
Total Entries : 3
DGS-3400:4#
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Used to remove a syslog host, that has been previously configured, from the
Switch.
delete syslog host [<index 1-4> | all]
The delete syslog host command is used to remove a syslog host that has
been previously configured from the Switch.
<index 1-4> − Specifies that the command will be applied to an index of hosts.
There are four available indexes, numbered 1 through 4.
all − Specifies that the command will be applied to all hosts.
Only administrator-level users can issue this command.
Used to display the syslog hosts currently configured on the Switch.
show syslog host {<index 1-4>}
The show syslog host command is used to display the syslog
hosts that are currently configured on the Switch.
<index 1-4> − Specifies that the command will be applied to an
index of hosts. There are four available indexes, numbered 1
through 4.
None.
---------------
10.1.1.2
10.40.2.3
10.21.13.1
Severity Facility
-------------- --------
All Local0 514
All Local0 514
All Local0 514
65
UDP port Status
-------- --------
Disabled
Disabled
Disabled