D-Link xStack DGS-3426 Cli Manual page 20

Example usage:
To disable the Telnet protocol on the Switch:
DGS-3400:4#disable telnet
Command: disable telnet
Success.
DGS-3400:4#
enable web
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable HTTP and configure port number:
DGS-3400:4#enable web 80
Command: enable web 80
Note: SSL will be disabled if web is enabled.
Success.
DGS-3400:4#
disable web
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable HTTP:
DGS-3400:4#disable web
Command: disable web
Success.
DGS-3400:4#
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Used to enable the HTTP-based management software on the
Switch.
enable web <tcp_port_number 1-65535>
This command is used to enable the Web-based management
software on the Switch.
<tcp_port_number 1-65535> − The TCP port number. TCP ports are
numbered between 1 and 65535. The "well-known" port for the Web-
based management software is 80.
Only administrator-level users can issue this command.
Used to disable the HTTP-based management software on the
Switch.
disable web
This command disables the Web-based management software on
the Switch.
None.
Only administrator-level users can issue this command.
17