D-Link xStack DGS-3426 Cli Manual page 210

config authen server_group
Restrictions
Example usage:
To add an authentication host to server group "group_1":
DGS-3400:4# config authen server_group group_1 add server_host
10.1.1.121 protocol tacacs+
Command: config authen server_group group_1 add server_host
10.1.1.121 protocol tacacs+
Success.
DGS-3400:4#
delete authen server_group
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete the server group "group_1":
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
protocol may be added to this group.
xtacacs – Use this parameter to utilize the built-in XTACACS
server protocol on the Switch. Only server hosts utilizing the
XTACACS protocol may be added to this group.
tacacs+ – Use this parameter to utilize the built-in TACACS+
server protocol on the Switch. Only server hosts utilizing the
TACACS+ protocol may be added to this group.
radius – Use this parameter to utilize the built-in RADIUS server
protocol on the Switch. Only server hosts utilizing the RADIUS
protocol may be added to this group.
<string 15> - Enter an alphanumeric string of up to 15 characters
to define the previously created server group. This group may add
any combination of server hosts to it, regardless of protocol.
add/delete – Enter the correct parameter to add or delete a server host
from a server group.
server_host <ipaddr> - Enter the IP address of the previously configured
server host to add or delete.
protocol – Enter the protocol utilized by the server host. There are three
options:
tacacs – Use this parameter to define the protocol if the server
host is using the TACACS authentication protocol.
xtacacs – Use this parameter to define the protocol if the server
host is using the XTACACS authentication protocol.
tacacs+ – Use this parameter to define the protocol if the server
host is using the TACACS+ authentication protocol.
radius – Use this parameter to define the protocol if the server
host is using the RADIUS authentication protocol.
Only administrator-level users can issue this command.
Used to delete a user-defined authentication server group.
delete authen server_group <string 15>
This command will delete an authentication server group.
<string 15> - Enter an alphanumeric string of up to 15 characters to
define the previously created server group to be deleted.
Only administrator-level users can issue this command.
207