D-Link xStack DGS-3426 Cli Manual page 146

config 802.1x reauth
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure 802.1x reauthentication for ports 1-18:
DGS-3400:4#config 802.1x reauth port_based ports 1-18
Command: config 802.1x reauth port_based ports 1-18
Success.
DGS-3400:4#
config radius add
Purpose
Syntax
Description
Parameters
Restrictions
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Used to configure the 802.1x re-authentication feature of the Switch.
config 802.1x reauth {port_based ports [<portlist> | all] |
mac_based [ports] [<portlist> | all] {mac_address <macaddr>}]
The config 802.1x reauth command is used to re-authenticate a
previously authenticated device based on port number.
port_based – This instructs the Switch to re-authorize 802.1x functions
based only on the port number. Ports approved for re-authorization
can then be specified.
mac_based − This instructs the Switch to re-authorize 802.1x functions
based only on the MAC address. MAC addresses approved for re-
authorization can then be specified.
ports <portlist> − Specifies a port or range of ports to be re-authorized.
all − Specifies all of the ports on the Switch.
mac_address <macaddr> - Enter the MAC address to be re-
authorized.
Only administrator-level users can issue this command.
Used to configure the settings the Switch will use to communicate with a
RADIUS server.
config radius add <server_index 1-3> <server_ip> key <passwd 32>
[default | {auth_port <udp_port_number 1-65535> | acct_port
<udp_port_number 1-65535>}]
The config radius add command is used to configure the settings the
Switch will use to communicate with a RADIUS server.
<server_index 1-3> − Assigns a number to the current set of RADIUS
server settings. Up to 3 groups of RADIUS server settings can be entered
on the Switch.
<server_ip> − The IP address of the RADIUS server.
key − Specifies that a password and encryption key will be used between
the Switch and the Radius server.
<passwd 32> − The shared-secret key used by the RADIUS server and
the Switch. Up to 32 characters can be used.
default − Uses the default udp port number in both the "auth_port" and
"acct_port" settings.
auth_port <udp_port_number 1-65535> − The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number 1-65535> − The UDP port number for
accounting requests. The default is 1813.
Only administrator-level users can issue this command.
143