Commands - D-Link xStack DGS-3426 Cli Manual

The DGS-3400 implements the server-side of the IEEE 802.1x Port-based and MAC-based Network Access Control. This
mechanism is intended to allow only authorized users, or other network devices, access to network resources by establishing
criteria for each port on the Switch that a user or network device must meet before allowing that port to forward or receive frames.
The 802.1X commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
enable 802.1x
disable 802.1x
show 802.1x auth_state
show 802.1x auth_configuration
config 802.1x auth_protocol
create 802.1x user
delete 802.1x user
show 802.1x user
show auth_statistics
show auth_diagnostics
show auth_session_statistics
show auth_client
show acct_client
config 802.1x capability ports
config 802.1x auth_parameter ports
config 802.1x init
config 802.1x auth_mode
config 802.1x reauth
config radius add
config radius delete
config radius
show radius
Each command is listed, in detail, in the following sections
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Parameters
{ports <portlist>}
{ports <portlist>}
[local | radius_eap]
<username 15>
<username 15>
{ports <portlist | all>}
{ports <portlist | all>}
{ports <portlist | all>}
[<portlist> | all] [authenticator | none]
[<portlist> | all] [default | {direction [both | in] | port_control
[force_unauth | auto | force_auth] | quiet_period <sec 0-
65535> | tx_period <sec 1-65535> | supp_timeout <sec 1-
65535> | server_timeout <sec 1-65535> | max_req <value 1-
10> | reauth_period <sec 1-65535> | enable_reauth [enable |
disable]}]
[port_based ports [<portlist> | all] | mac_based [ports]
[<portlist> |all] {mac_address <macaddr>}]
[port_based | mac_based]
{port_based ports [<portlist> | all] | mac_based [ports]
[<portlist> | all] {mac_address <macaddr>}]
<server_index 1-3> <server_ip> key <passwd 32> [default |
{auth_port <udp_port_number 1-65535> | acct_port
<udp_port_number 1-65535>}]
<server_index 1-3>
<server_index 1-3> {ipaddress <server_ip> | key <passwd
32> [auth_port <udp_port_number 1-65535> acct_port
<udp_port_number 1-65535>]}
136
802.1X C
OMMANDS
20