Network Monitoring Commands; Show Packet Ports - D-Link DES-1210-28/ME Reference Manual

The Network Monitoring commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command

show packet ports

show error ports
show utilization
clear counters
clear log
show log
enable syslog
disable syslog
show syslog
create syslog host
config syslog host
delete syslog host
show syslog host
cable diagnostic port
Each command is listed in detail, as follows:
show packet ports
Purpose
Syntax
Description
Parameters
DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide

NETWORK MONITORING COMMANDS

Parameter
<portlist>
<portlist>
[ports {<portlist>} | cpu | mem]
{index <value 1-500> - <value 1-500>}
<index 1-4> ipaddress <ipaddr> {severity [informational | warning | all] | facility
[local0 | local1| local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number>}
[all | <index 1-4>] {severity [informational | warning | all] | facility [local0 | local1 |
local2 | local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number> |
ipaddress <ipaddr>}
[<index 1-4> | all]
{<index 1-4>}
[<portlist> | all]
To display statistics about the packets sent and received in frames
per second by the Switch.
show packet ports <portlist>
The show packet ports command displays statistics about packets
sent and received by ports specified in the port list. The results are
separated into three tables, labeled A, B, and C in the window
below. Table A is relevant to the size of the packets, Table B is
relevant to the type of packets and Table C is relevant to the type of
frame associated with these packets.
<portlist> − A port or range of ports whose statistics are to be
displayed.
94
17 17 17 17