D-Link xStack DGS-3426 Cli Manual page 66

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
config syslog host all
Purpose Used to configure the syslog protocol to send system log data to a remote
host.
Syntax config syslog host all [severity [informational | warning | all] | facility
[local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] |
udp_port <udp_port_number> | state [enable | disable]]
Description The config syslog host all command is used to configure the syslog
protocol to send system log information to a remote host.
all − Specifies that the command will be applied to all hosts.
Parameters
severity − Severity level indicator, as described below:
Bold font indicates that the corresponding severity level is currently
supported on the Switch.
Numerical
Code
0 Emergency: system is unusable
1 Alert: action must be taken immediately
2 Critical: critical conditions
3 Error: error conditions
4 Warning: warning conditions
5 Notice: normal but significant condition
6 Informational: informational messages
7 Debug: debug-level messages
informational − Specifies that informational messages will be sent to the
remote host. This corresponds to number 6 from the list above.
warning − Specifies that warning messages will be sent to the remote host.
This corresponds to number 4 from the list above.
all − Specifies that all of the currently supported syslog messages that are
generated by the Switch will be sent to the remote host.
facility − Some of the operating system daemons and processes have been
assigned Facility values. Processes and daemons that have not been
explicitly assigned a Facility may use any of the "local use" facilities or they
may use the "user-level" Facility. Those Facilities that have been
designated are shown in the following: Bold font indicates that the facility
values the Switch currently supports.
Numerical
Code
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
Severity
Facility
kernel messages
user-level messages
mail system
system daemons
security/authorization messages
messages generated internally by syslog
line printer subsystem
network news subsystem
UUCP subsystem
clock daemon
security/authorization messages
FTP daemon
NTP subsystem
log audit
log alert
clock daemon
local use 0 (local0)
local use 1 (local1)
local use 2 (local2)
local use 3 (local3)
local use 4 (local4)
local use 5 (local5)
63