D-Link xStack DGS-3426 Cli Manual page 188

create iproute ipv6
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To add a single static IPv6 entry in IPv6 format:
delete iproute ipv6
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To delete a static IPv6 entry from the routing table:
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Used to create Ipv6 route entries to the Switch's IP routing table.
create iproute ipv6 <ipv6networkaddr> < ipv6addr > {<metric 1-65535>}
This command is used to create a primary and backup IP route entry to the
Switch's IP routing table.
<ipv6networkaddr> − IPV6 address and netmask of the IP interface that is the
destination of the route. Specify the address and mask information using the
format as ipv6address / prefix_length (ipv6address is hexadecimal number,
prefix length is decimal number, for example 1234::5D7F/32).
<ipv6addr> − IPv6 address for the next hop router.
<metric 1-65535> − Allows the entry of a routing protocol metric entry,
representing the number of routers between the Switch and the IP address
above. The default setting is 1.
Only administrator-level users can issue this command.
DGS-3400:4# create iproute 1234::5D7F/32 2D30::AC21
Command: create iproute 1234::5D7F/32 2D30::AC21
Success.
DGS-3400:4#
Used to delete an static IPv6 route entry from the Switch's IP routing
table.
delete iproute ipv6 {<ipv6networkaddr> <ipv6addr> | all}
This command will delete an existing static IPv6 entry from the Switch's
IP routing table.
<ipv6networkaddr> − IPV6 address and netmask of the IP interface that
is the destination of the route. Specify the address and mask information
using the format as ipv6address / prefix_length (ipv6address is
hexadecimal number, prefix length is decimal number, for example
1234::5D7F/32).
<ipv6addr> − IPv6 address for the next hop router.
all − This will delete all IPv6 static entries for the destination and next
hop.
Only administrator-level users can issue this command.
185