Network Monitoring Commands - D-Link DES-1228/ME Reference Manual

The Network Monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table:
Command
show packet ports
show error ports
show utilization
clear counters
clear log
show log
enable syslog
disable syslog
show syslog
create syslog host
config syslog
delete syslog host
show syslog host
config log_save_timing
show log_save_timing
enable command
logging
disable command
logging
show command logging
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
N
Parameters
<portlist>
<portlist>
[cpu | dram | flash | ports {<portlist>}]
{ports <portlist>}
{index <value_list X-Y>}
<index 1-4> {severity [informational | warning | all] | facility [local0 |
local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number>| ipaddress [<ipaddr>] | state [enable |
disable] }
{host [all | <index 1-4>]} {severity [informational | warning | all] |
facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 |
local7] | udp_port <udp_port_number> | ipaddress [<ipaddr>] |
state [enable | disable]}
[<index 1-4> | all]
{<index 1-4>}
[time_interval <min 1-65535> | on_demand | log_trigger]
M
ETWORK ONITORING
88
10
C
OMMANDS