D-Link xStack DGS-3426 Cli Manual page 140

enable 802.1x
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable 802.1x switch wide:
disable 802.1x
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable 802.1x on the Switch:
DGS-3400:4#disable 802.1x
Command: disable 802.1x
Success.
DGS-3400:4#
show 802.1x auth_configuration
Purpose
Syntax
Description
Parameters
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Used to enable the 802.1x server on the Switch.
enable 802.1x
The enable 802.1x command enables the 802.1x Network Access
control server application on the Switch. To select between port-
based or MAC-based, use the config 802.1x auth_mode command.
None.
Only administrator-level users can issue this command.
DGS-3400:4#enable 802.1x
Command: enable 802.1x
Success.
DGS-3400:4#
Used to disable the 802.1x server on the Switch.
disable 802.1x
The disable 802.1x command is used to disable the 802.1x Network
Access control server application on the Switch. To select between port-
based or MAC-based, use the config 802.1x auth_mode command.
None.
Only administrator-level users can issue this command.
Used to display the current configuration of the 802.1x server on the
Switch.
show 802.1x auth_configuration {ports <portlist>}
The show 802.1x user command is used to display the 802.1x Port-
based or MAC-based Network Access control local users currently
configured on the Switch.
ports <portlist> − Specifies a port or range of ports to view.
The following details are displayed:
802.1x Enabled / Disabled − Shows the current status of 802.1x functions
on the Switch.
Authentication Mode – Shows the authentication mode, whether it be by
137