D-Link xStack DGS-3426 Cli Manual page 198

Example usage:
To display the system access authentication policy:
DGS-3400:4#show authen_policy
Command: show authen_policy
Authentication Policy: Enabled
DGS-3400:4#
create authen_login method_list_name
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create the method list "Trinity.":
DGS-3400:4#create authen_login method_list_name Trinity
Command: create authen_login method_list_name Trinity
Success.
DGS-3400:4#
config authen_login
Purpose
Syntax
Description
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Used to create a user defined method list of authentication methods
for users logging on to the Switch.
create authen_login method_list_name <string 15>
This command is used to create a list for authentication techniques
for user login. The Switch can support up to eight method lists, but
one is reserved as a default and cannot be deleted. Multiple method
lists must be created and configured separately.
<string 15> - Enter an alphanumeric string of up to 15 characters to
define the given method list.
Only administrator-level users can issue this command.
Used to configure a user-defined or default method list of authentication methods for user
login.
config authen_login [default | method_list_name <string 15>] method {tacacs |
xtacacs | tacacs+ | radius | server_group <string 15> | local | none}
This command will configure a user-defined or default method list of authentication
methods for users logging on to the Switch. The sequence of methods implemented in this
command will affect the authentication result. For example, if a user enters a sequence of
methods like tacacs – xtacacs – local, the Switch will send an authentication request to the
first tacacs host in the server group. If no response comes from the server host, the Switch
will send an authentication request to the second tacacs host in the server group and so
on, until the list is exhausted. At that point, the Switch will restart the same sequence with
the following protocol listed, xtacacs. If no authentication takes place using the xtacacs list,
the local account database set in the Switch is used to authenticate the user. When the
local method is used, the privilege level will be dependant on the local account privilege
configured on the Switch.
Successful login using any of these methods will give the user a "user" priviledge only. If
the user wishes to upgrade his or her status to the administrator level, the user must
implement the enable admin command, followed by a previously configured password.
(See the enable admin part of this section for more detailed information, concerning the
enable admin command.)
195