D-Link xStack DGS-3426 Cli Manual page 167

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
config cpu access_profile
above.
profile_id <value 1-5> − Enter an integer used to identify the access profile that will be
Parameters
configured with this command. This value is assigned to the access profile when it is created
with the create access_profile command. The profile ID sets the relative priority for the profile
and specifies an index number that will identify the access profile being created with this
command. Priority is set relative to other profiles where the lowest profile ID has the highest
priority.
• add access_id <value 1-100> − Adds an additional rule to the above specified
ethernet − Specifies that the Switch will look only into the layer 2 part of each packet.
• vlan <vlan_name 32> − Specifies that the access profile will apply to only to this
• source_mac <macaddr> − Specifies that the access profile will apply to this source
• destination_mac <macaddr> − Specifies that the access profile will apply to this
• ethernet_type <hex 0x0-0xffff> − Specifies that the access profile will apply only to
ip − Specifies that the Switch will look into the IP fields in each packet.
• vlan <vlan_name 32> − Specifies that the access profile will apply to only this
• source_ip <ipaddr> − Specifies that the access profile will apply to only packets with
• destination_ip <ipaddr> − Specifies that the access profile will apply to only packets
• dscp <value 0-63> − Specifies that the access profile will apply only to packets that
• icmp − Specifies that the Switch will examine the Internet Control Message Protocol
• igmp − Specifies that the Switch will examine the Internet Group Management
• tcp − Specifies that the Switch will examine the Transmission Control Protocol (TCP)
• protocol_id <value 0-255> − Specifies that the switch will examine the Protocol field
• udp − Specifies that the Switch will examine the Transmission Control Protocol
• protocol_id <value 0-255> − Specifies that the Switch will examine the protocol field
access profile. The value is used to index the rule created.
VLAN.
MAC address.
destination MAC address.
packets with this hexadecimal 802.1Q Ethernet type value in the packet header.
VLAN.
this source IP address.
with this destination IP address.
have this value in their Type-of-Service (DiffServ code point, DSCP) field in their IP
packet header
(ICMP) field within each packet.
• type <value 0-255> − Specifies that the access profile will apply to this ICMP
type value.
• code <value 0-255> − Specifies that the access profile will apply to this ICMP
code.
Protocol (IGMP) field within each packet.
• type <value 0-255> − Specifies that the access profile will apply to packets that
have this IGMP type value.
field within each packet.
• src_port <value 0-65535> − Specifies that the access profile will apply only to
packets that have this TCP source port in their TCP header.
• dst_port <value 0-65535> − Specifies that the access profile will apply only to
packets that have this TCP destination port in their TCP header.
in each packet and if this field contains the value entered here, apply the following
rules.
(TCP) field within each packet.
• src_port <value 0-65535> − Specifies that the access profile will apply only to
packets that have this UDP source port in their header.
• dst_port <value 0-65535> − Specifies that the access profile will apply only to
packets that have this UDP destination port in their header.
in each packet and if this field contains the value entered here, apply the following
164