DGS-3400:4# config scheduling 0 max_packet 12
Command: config scheduling 0 max_packet 12
Success.
DGS-3400:4#
show scheduling
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the current scheduling configuration:
DGS-3400:4#show scheduling
Command: show scheduling
QOS Output Scheduling
Class-0
Class-1
Class-2
Class-3
Class-4
Class-5
Class-6
DGS-3400:4#
config 802.1p user_priority
Purpose
Syntax
Description
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Used to display the currently configured traffic scheduling on the
Switch.
show scheduling
The show scheduling command will display the current traffic
scheduling mechanisms in use on the Switch.
None.
None.
MAX. Packets
-------------
1
2
3
4
5
6
7
Used to map the 802.1p user priority of an incoming packet to one
of the seven hardware queues available on the Switch.
config 802.1p user_priority <priority 0-7> <class_id 0-6>
This command allows you to configure the way the Switch will map
an incoming packet, based on its 802.1p user priority, to one of the
seven available hardware priority queues on the Switch.
The Switch's default is to map the following incoming 802.1p user
priority values to the seven hardware priority queues:
802.1p
0
1
2
3
4
5
6
7
Hardware Queue
Remark
2
Mid-low
0
Lowest
1
Lowest
3
Mid-low
4
Mid-high
5
Mid-high
6
Highest
6
Highest
94