Network Monitoring Commands - D-Link xStackTM DGS-3300 User Manual

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
show packet ports
show error ports
show utilization
clear counters
clear log
show log
enable syslog
disable syslog
show syslog
create syslog host
config syslog host
config syslog host all
delete syslog host
show syslog host
config
system_severity
show system_severity
Each command is listed, in detail, in the following sections.
N
ETWORK
Parameters
<portlist>
<portlist>
[ports | cpu]
ports <portlist>
index <value_list>
[<index 1-4> | all] {severity [informational | warning | all] | facility
[local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] |
udp_port <udp_port_number> | ipaddress <ipaddr> | state [enable
| disable]}
<index 1-4> {severity [informational | warning | all] | facility [local0 |
local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number> | ipaddress <ipaddr> | state [enable |
disable]}
{severity [informational | warning | all] | facility [local0 | local1 |
local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number> | state [enable | disable]}
[<index 1-4> | all]
[<index 1-4>]
[trap | log | all] [critical | warning | information]
58
M
ONITORING
9
C
OMMANDS