Example usage:
To configure configuration section 1 as a boot up section:
config firmware
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure firmware section 1 as a boot up section:
show firmware information
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the current firmware information on the Switch:
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
DGS-3400:4#config configuration 1 boot_up
Command: config configuration 1 boot_up
Success.
DGS-3400:4#
Used to configure the firmware section as a boot up section, or to
delete the firmware section
config firmware image_id <int 1-2> [delete | boot_up]
This command is used to configure the firmware section. The user
may choose to remove the firmware section or use it as a boot up
section.
image_id – Specifies the working section. The Switch can hold two
firmware versions for the user to select from, which are specified by
image ID.
<int 1-2> - Select the ID number of the firmware in the Switch's
memory to be configured.
delete – Entering this parameter will delete the specified firmware
section.
boot_up – Entering this parameter will specify the firmware image ID
as a boot up section.
Only administrator-level users can issue this command.
DGS-3400:4# config firmware image_id 1 boot_up
Command: config firmware image_id 1 boot_up
Success.
DGS-3400:4#
Used to display the firmware section information.
show firmware information
This command is used to display the firmware section information
None.
None
48