Ip-Mac Binding Commands - D-Link xStack DGS-3426 Cli Manual

The IP-MAC Binding commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
create address_binding ip_mac
ipaddress
config address_binding ip_mac
ipaddress
config address_binding ip_mac ports
show address_binding
delete address-binding
Each command is listed, in detail, in the following sections.
create address_binding ip_mac ipaddress
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create address binding on the Switch:
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Used to create an IP-MAC Binding entry.
create address_binding ip_mac ipaddress <ipaddr>
mac_address <macaddr> { ports [ portlist | all]}
This command will create an IP-MAC Binding entry.
<ipaddr> The IP address of the device where the IP-MAC binding
is made.
<macaddr> The MAC address of the device where the IP-MAC
binding is made.
ports [portlist | all] - Used to specify the ports where the IP-MAC
binding entry applies. If no ports are specified the binding applies
to all ports.
Only administrator-level users can issue this command.
DGS-3400:4#create address_binding ip_mac ipaddress 10.1.1.3
mac_address 00-00-00-00-00-04
Command: create address_binding ip_mac ipaddress 10.1.1.3
mac_address 00-00-00-00-00-04
Success.
DGS-3400:4#
IP-MAC B
Parameters
<ipaddr> mac_address <macaddr> {ports [ portlist | all]}
<ipaddr> mac_address <macaddr> {ports [ portlist | all]}
[<portlist> | all] state [enable | disable]
[ip_mac {[all | ipaddress <ipaddr> mac_address
<macaddr>]} | blocked {[all | vlan_name <vlan_name>
mac_address <macaddr>]} | ports]
[ip-mac [ipaddress <ipaddr> mac_address <macaddr>
|all] | blocked [all | vlan_name <vlan_name>
mac_address <macaddr>]]
114
17
C
INDING OMMANDS