D-Link xStack DGS-3426 Cli Manual page 31

Command
create snmp host
delete snmp host
show snmp host
create trusted_host
delete trusted_host
show trusted_host
enable snmp traps
enable snmp authenticate traps
show snmp traps
disable snmp traps
disable snmp authenticate traps
config snmp system_contact
config snmp system_location
config snmp system_name
enable rmon
disable rmon
Each command is listed, in detail, in the following sections.
create snmp user
Purpose
Syntax
Description
Parameters
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Parameters
<ipaddr> {v1 | v2c | v3 [noauth_nopriv | auth_nopriv | auth_priv]}
<auth_string 32>
<ipaddr>
<ipaddr>
<ipaddr>
<ipaddr>
<ipaddr>
<sw_contact>
<sw_location>
<sw_name>
Used to create a new SNMP user and adds the user to an SNMP group that is
also created by this command.
create snmp user <username 32> <groupname 32> {encrypted
[by_password auth [md5 <auth_password 8-16> | sha <auth_password 8-
20>] priv [none | des <priv_password 8-16>] | by_key auth [md5 <auth_key
32-32> | sha <auth_key 40-40>] priv [none | des <priv_key 32-32>]]}
The create snmp user command creates a new SNMP user and adds the user
to an SNMP group that is also created by this command. SNMP ensures:
Message integrity − Ensures that packets have not been tampered with during
transit.
Authentication − Determines if an SNMP message is from a valid source.
Encryption − Scrambles the contents of messages to prevent it from being
viewed by an unauthorized source.
<username 32> − An alphanumeric name of up to 32 characters that will identify
the new SNMP user.
<groupname 32> − An alphanumeric name of up to 32 characters that will
identify the SNMP group the new SNMP user will be associated with.
encrypted – Allows the user to choose a type of authorization for authentication
using SNMP. The user may choose:
•
by_password – Requires the SNMP user to enter a password for
authentication and privacy. The password is defined by specifying the
auth_password below. This method is recommended.
•
by_key – Requires the SNMP user to enter a encryption key for
authentication and privacy. The key is defined by specifying the key in
hex form below. This method is not recommended.
auth - The user may also choose the type of authentication algorithms used to
authenticate the snmp user. The choices are:
28