D-Link xStack DGS-3426 Cli Manual page 52

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
DGS-3400:4#show firmware information
Command: show firmware information
ID Version Size(B)
-- --------- -------
1 1.00-B27 2013171
*2 1.00-B30 2013334
'*' means boot up firmware
(R) means firmware update thru Serial Port(RS232)
(T) means firmware update thru TELNET
(S) means firmware update thru SNMP
(W) means firmware update thru WEB
(SIM) means firmware update thru Single IP Management
DGS-3400:4#
show config
Purpose Used to display the current or saved version of the configuration settings of
the switch.
Syntax show config [current_config | config_in_nvram <config_id 1-2> |
information]
Description Use this command to display all the configuration settings that are saved to
NV RAM or display the configuration settings as they are currently
configured. Use the keyboard to list settings one line at a time (Enter), one
page at a time (Space) or view all (a).
The configuration settings are listed by category in the following order:
Parameters current_config – Entering this parameter will display configurations entered
without being saved to NVRAM.
config_in_nvram <config_id 1-2> - Entering this parameter will display
configurations to be specified <config_id 1-2> which were saved in NV-
RAM.
Restrictions None.
Update Time
-------------------
0 days 00:00:00
2005/12/12 11:50:15 10.41.44.44(W)
1. Basic (serial port, Telnet
and web management
status)
2. storm control
3. IP group management
4. syslog
5. QoS
6. port mirroring
7. traffic segmentation
8. SSL
9. port
10. Port lock
11. ADDRBIND
12. 802.1x
13. SNMPv3
14. MANAGEMENT
15. VLAN
16. FDB (forwarding data
base)
49
From User
------------------ ---------------
Serial Port(Prom) Unknown
17. MAC ADDRESS TABLE
NOTIFICATION
18. STP
19. SAFEGUARD ENGINE
20. BANNER PROMPT
21. SSH
22. ACL
23. SNTP
24. LACP
25. IP and auto config
26. IGMP Snooping
27. MLD Snooping
28. ACCESS
AUTHENTICATION
CONTROL
29. ARP
30. Route