D-Link xStack DGS-3426 Cli Manual page 79

config stp mst_ports
Restrictions
Example usage:
To designate ports 1 to 2 on, with instance ID 0, to have an auto internalCost and a priority of 0:
DGS-3400:4#config stp mst_ports 1-2 instance_id 0 internalCost auto priority 0
Command: config stp mst_ports 1-2 instance_id 0 internalCost auto priority 0
Success.
DGS-3400:4#
show stp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the status of STP on the Switch:
Status 1: STP enabled with STP compatible version
DGS-3400:4#show stp
Command: show stp
STP Status
STP Version
Max Age
Hello Time
Forward Delay
Max Age
TX Hold Count
Forwarding BPDU
Loopback Detection
LBD Recover Time
DGS-3400:4#
Status 2 : STP enabled for RSTP
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
occurs. A lower internalCost represents a quicker transmission.
priority <value 0-240> - Enter a value between 0 and 240 to set the
priority for the port interface. A higher priority will designate the interface
to forward packets first. A lower number denotes a higher priority.
Only administrator-level users can issue this command.
Used to display the Switch's current STP configuration.
show stp
This command displays the Switch's current STP configuration.
None.
None.
: Enabled
: STP Compatible
: 20
: 2
: 15
: 20
: 3
: Enabled
: Enabled
: 60
76