D-Link xStack DGS-3426 Cli Manual page 56

show autoconfig
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To view the autoconfiguration status:
DGS-3400:4#show autoconfig
Command: show autoconfig
Autoconfig State: Disabled.
DGS-3400:4#
ping
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To ping the IP address 10.48.74.121 four times:
DGS-3400:4#ping 10.48.74.121 times 4
Command: ping 10.48.74.121
Reply from 10.48.74.121, time<10ms
Reply from 10.48.74.121, time<10ms
Reply from 10.48.74.121, time<10ms
Reply from 10.48.74.121, time<10ms
Ping statistics for 10.48.74.121
Packets: Sent =4, Received =4, Lost =0
DGS-3400:4#
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Used to display the current autoconfig status of the Switch.
show autoconfig
This will list the current status of the autoconfiguration function.
None.
Only administrator-level users can issue this command.
Used to test the connectivity between network devices.
ping <ipaddr> {times <value 1-255>} {timeout <sec 1-99>}
The ping command sends Internet Control Message Protocol (ICMP)
echo messages to a remote IP address. The remote IP address will
then "echo" or return the message. This is used to confirm
connectivity between the Switch and the remote device.
<ipaddr> - Specifies the IP address of the host.
times <value 1-255> - The number of individual ICMP echo
messages to be sent. The maximum value is 255.
timeout <sec 1-99> - Defines the time-out period while waiting for a
response from the remote device. A value of 1 to 99 seconds can be
specified. The default is 1 second
None.
53