D-Link xStack DGS-3426 Cli Manual page 53

Example usage:
To view the current configuration settings:
DGS-3450:4#show config current_config
Command: show config current_config
#-------------------------------------------------------------------------------
#
#
#
#
# Copyright(C) 2004-2007 D-Link Corporation. All rights reserved.
#-------------------------------------------------------------------------------
# STACK
# BASIC
config serial_port auto_logout never
enable telnet 50000
enable web 60000
enable clipaging
# STORM
config traffic trap none
config traffic control 1-50 broadcast disable multicast disable dlf disable action
drop threshold 1024 countdown 0 time_interval 5
upload
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To upload a configuration file:
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
DGS-3450 Gigabit Ethernet Switch
Configuration
Firmware: Build 1.20-B15
Used to upload switch settings or the switch history log to a TFTP.
upload [config <ipaddr> <path_filename 64> {<config_id 1-2>} |
log_toTFTP <ipaddr> <path_filename 64>]
This command is used to upload either the Switch's current settings or the
Switch's history log to a TFTP server.
config − Specifies that the Switch's current settings will be uploaded to the
TFTP server.
<config_id 1-2> - Entering this parameter will upload configurations to be
specified, which were saved in NV-RAM to TFTP server.
log_toTFTP − Specifies that the switch history log will be uploaded to the
TFTP server.
<ipaddr> − The IP address of the TFTP server. The TFTP server must be
on the same IP subnet as the Switch.
<path_filename 64> − Specifies the location of the Switch configuration file
on the TFTP server. This file will be replaced by the uploaded file from the
Switch.
Only administrator-level users can issue this command.
50