Network Monitoring Commands - D-Link xStack DES-3200 Series Reference Manual

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
The Network Monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table:
Command
show packet ports
show error ports
show utilization
clear counters
clear log
show log
enable syslog
disable syslog
show syslog
create syslog host
config syslog
delete syslog host
show syslog host
config log_save_timing
show log_save_timing
delete ipif
enable
ipif_ipv6_link_local_auto
disable
ipif_ipv6_link_local_auto
show
ipif_ipv6_link_local_auto
Each command is listed, in detail, in the following sections:
N
ETWORK
Parameters
<portlist>
<portlist>
[cpu | dram | flash | ports {<portlist>}]
{ports <portlist>}
{index <value_list X-Y>}
<index 1-4> {severity [informational | warning | all] | facility [local0 |
local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number>| ipaddress [<ipaddr>] | state [enable |
disable] }
{host [all | <index 1-4>]} {severity [informational | warning | all] |
facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 |
local7] | udp_port <udp_port_number> | ipaddress [<ipaddr>] |
state [enable | disable]}
[<index 1-4> | all]
{<index 1-4>}
[time_interval <min 1-65535> | on_demand | log_trigger]
[System] [ipv6adress <ipv6networkaddr>]
[System]
[System]
82
M
ONITORING
10
C
OMMANDS