The Network Monitoring commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
show packet ports
show error ports
show utilization
clear counters
save log
clear log
show log
enable syslog
disable syslog
show syslog
create syslog host
config syslog host
delete syslog host
show syslog host
cable diagnostic port
config syslogintimeout
config sysgroupinterval
show
log_software_module
Each command is listed in detail, as follows:
show packet ports
Purpose
Syntax
DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
NETWORK MONITORING COMMANDS
Parameter
<portlist>
<portlist>
[ports {<portlist>} | cpu | mem]
{ports <portlist>}
{index <indexlist> | module <string 32> | severity [all | information | warning]}
<index 1-4> ipaddress [<ipaddr> | <ipv6addr>] {severity [informational | warning |
all] | facility [local0 | local1| local2 | local3 | local4 | local5 | local6 | local7] | state
[enable | disable] | udp_port [514 | <udp_port_number 6000-65535>]}
[all | <index 1-4>] {severity [informational | warning | all] | facility [local0 | local1 |
local2 | local3 | local4 | local5 | local6 | local7] | state [enable | disable] | udp_port
[ 514 | <udp_port_number 6000-65535>] | ipaddress [<ipaddr> | <ipv6addr>]}
[<index 1-4> | all]
{<index 1-4>}
[<portlist> | all]
<integer 3-30>
[<integer 120-1225> | 0]
To display statistics about the packets sent and received in frames
per second by the Switch.
show packet ports <portlist>
139
20