D-Link xStack DGS-3426 Cli Manual page 133

config mld_snooping
Restrictions
Example usage:
To configure MLD snooping:
DGS-3400:4#config mld_snooping vlan default node_timeout 250 state enable
Command : config mld_snooping vlan default node_timeout 250 state enable
Success.
DGS-3400:4#
config mld_snooping mrouter_ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure MLD snooping multicast router ports:
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
be configured.
all – Entering this parameter will configure MLD snooping for all VLANs on the
switch.
node_timeout <sec 1-16711450> − Specifies the link node timeout, in
seconds. After this timer expires, this node will no longer be considered as
listening node. The user may specify a time between 1 and 16711450 with a
default setting of 260 seconds.
router_timeout <sec 1-16711450> − Specifies the maximum amount of time a
router can remain in the Switch's routing table as a listening node of a
multicast group without the Switch receiving a node listener report. The user
may specify a time between 1 and 16711450 with a default setting of 260
seconds.
done_timer <sec 1-16711450> − Specifies the maximum amount of time a
router can remain in the Switch after receiving a done message from the group
without receiving a node listener report. The user may specify a time between
1 and 16711450 with a default setting of 2 seconds.
state [enable | disable] − Allows you to enable or disable MLD snooping for the
specified VLAN.
fast_done [enable | disable] – This parameter allows the user to enable the
fast done function. Enabled, this function will allow members of a multicast
group to leave the group immediately when a done message is received by the
Switch.
Only administrator-level users can issue this command.
Used to configure ports as router ports on the Switch.
config mld_snooping mrouter_ports <vlan_name 32> [add | delete]
<portlist>
This command allows you to designate a range of ports as being connected to
a multicast-enabled router. This command will ensure that all packets with this
router as its destination will reach the multicast-enabled router.
vlan <vlan_name 32> − The name of the VLAN on which the router port
resides.
add | delete – Specify to add or delete ports as router ports.
<portlist> - Specify a port or range of ports to be configured as router ports.
Only administrator-level users can issue this command.
130