D-Link xStack DGS-3426 Cli Manual page 113

delete link_aggregation group_id
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete link aggregation group:
config link_aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To define a load-sharing group of ports, group-id 1,master port 5 with group members ports 5-7 plus port 9:
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
DGS-3400:4#create link_aggregation group_id 1
Command: create link_aggregation group_id 1
Success.
DGS-3400:4#
Used to delete a previously configured link aggregation group.
delete link_aggregation group_id <value 1-32>
This command is used to delete a previously configured link
aggregation group.
<value 1-32> − Specifies the group ID. The Switch allows up to 32
link aggregation groups to be configured. The group number
identifies each of the groups.
Only administrator-level users can issue this command.
DGS-3400:4#delete link_aggregation group_id 6
Command: delete link_aggregation group_id 6
Success.
DGS-3400:4#
Used to configure a previously created link aggregation group.
config link_aggregation group_id <value 1-32> {master_port <port>
| ports <portlist> | state [enable | disable]
This command allows you to configure a link aggregation group that was
created with the create link_aggregation command above. The DGS-
3400 supports link aggregation cross box which specifies that link
aggregation groups may be spread over multiple switches in the
switching stack.
group _id <value 32> − Specifies the group ID. The Switch allows up to
32 link aggregation groups to be configured. The group number
identifies each of the groups.
master_port <port> − Master port ID. Specifies which port (by port
number) of the link aggregation group will be the master port. All of the
ports in a link aggregation group will share the port configuration with
the master port.
ports <portlist> − Specifies a port or range of ports that will belong to the
link aggregation group.
state [enable | disable] − Allows you to enable or disable the specified
link aggregation group.
Only administrator-level users can issue this command. Link
aggregation groups may not overlap.
110