D-Link xStack DGS-3426 Cli Manual page 189

show iproute ipv6
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To display the static IPv6 entries in the routing table:
DGS-3400:4# show iproute ipv6
Command: show iproute ipv6
Routing Table
IPV6 Address/Netmask
--------------------------------
1234::/32
Total Entries: 1
DGS-3400:4#
create iproute ipv6 default
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To add the default static address 1234::5D7F/32, with a metric setting of 1, to the routing table:
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
DGS-3400:4# delete iproute 1234::5D7F/32 2D30::AC21
Command: delete iproute 1234::5D7F/32 2D30::AC21
Success.
DGS-3400:4#
Used to display the Switch's current static IPv6 routing table or a
specified IPv6 address.
show iproute ipv6 {<ipv6networkaddr>}
This command will display the Switch's current static IPv6 routing table
or a specific IPv6 entry.
<ipv6networkaddr> − IPV6 address and netmask of the IP interface that
is the destination of the route. Specify the address and mask
information using the format as ipv6address / prefix_length
(ipv6address is hexadecimal number, prefix length is decimal number,
for example 1234::5D7F/32).
None.
Used to create IP route entries to the Switch's IP routing table.
create iproute ipv6 default <ipv6addr> {<metric 1-65535>}
This command is used to create a default static IP route entry to the Switch's
IP routing table.
<ipv6addr> − The gateway IPv6 address for the next hop router.
<metric 1-65535> − Allows the entry of a routing protocol metric entry
representing the number of routers between the Switch and the IP address
above. The default setting is 1.
Only administrator-level users can issue this command.
Gateway Cost
------------------------ --------
2D30::AC21 1
186
Protocol
--------
Static