[Sense[1]]|Sense2:Speed <Numeric_Value - HP E4418B Programming Manual

SENSe Subsystem
[SENSe[1]]|SENSe2:SPEed <numeric_value>
[SENSe[1]]|SENSe2:SPEed <numeric_value>
This command is used to select the measurement speed on the selected
channel. The speeds available are 20, 40 and 200 readings/second. Refer to
"Getting the Best Speed Performance", on page 1-66 for further
information.
When a channel is set to 200 readings/second the following couplings
occur.
1. This change only occurs on the channel specified in the SENSe:SPEed
command. When the specified channel is changed from 200 readings/second to
either 20 or 40 readings/second the settings that were in place when 200
readings/second mode was entered are restored.
2. This change occurs when either channel is set to 200 readings/second. When
both channels are changed from 200 readings/second to either 20 or 40
readings/second the settings that were in place when 200 readings/second mode
was entered are restored.
Syntax
9-54
Command
[SENSe[1]]|SENSe2:AVERage:STATe
[SENSe[1]]|SENSe2:LIMit:STATe
[SENSe[1]]|SENSe2:CORRection:DCYCle:STATe
[SENSe[1]]|SENSe2:CORRection:GAIN2:STATe
CALCulate[1|2]:GAIN:STATe
CALCulate[1|2]:RELative:STATe
CALCulate1:MATH:EXPRession
CALCulate2:MATH:EXPRession
SENS 1
SENS2
Space
:
SPE
HP E4418B/E4419B Programming Guide
Status
1
OFF
1
OFF
1
OFF
1
OFF
2
OFF
2
OFF
"(SENSe1)"
"(SENSe2)"
numeric_value
?