Query
[SENSe[1]]|SENSe2:LIMit:CLEar:AUTO?
The query command enters a 1 or 0 into the output buffer indicating
whether limit failures are cleared automatically when a new
measurement is initiated on the specified channel.
In the case where limit failures are cleared once, when a query occurs a 1
is entered into the output buffer if no measurement is initiated. If a
measurement is initiated then 0 is entered.
Query Example
HP E4418B/E4419B Programming Guide
[SENSe[1]]|SENSe2:LIMit:CLEar:AUTO <Boolean>|ONCE
•
1 is entered into the output buffer when limit failures are cleared
automatically when a new measurement is initiated.
•
0 is entered into the output buffer when limit failures are not
cleared automatically when a new measurement is initiated.
SENS1:LIM:CLE:AUTO?
SENSe Subsystem
This command queries when the
FCO is cleared for channel A.
9-41