[Sense[1]]|Sense2:Correction:dcycle|Gain3 Node - HP E4418B Programming Manual

[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3 Node

This command node controls the pulse power measurement feature of the
power meter.
The commands associated with this node are:
[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3[:INPut]
[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3:STATe <Boolean>
Note
HP E4418B/E4419B Programming Guide
[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3 Node
[:MAGNitude] <numeric_value>
You can use either DCYCLe or GAIN3 in these commands, both do
the same. Using GAIN3 complies with the SCPI standard whereas
DCYCle does not, but may make your program more
understandable.
SENSe Subsystem
9-19