HP E4418B Programming Manual page 68

Power Meter Remote Operation
Using Frequency Dependent Offset Tables
Each string parameter returned indicates the name, type and size of a
stored frequency dependent offset table:
•
<string>,<type>,<size>
The <string>, <type> and <size> are all character data. The
<type> is always TABL. The <size> is displayed in bytes.
For example, a sample of the response may look like:
560,8020,"Offset_1,TABL,220","Offset_2,TABL,340" ....
Naming Frequency Dependent Offset Tables
To rename a frequency dependent offset table use:
MEMory:TABLe:MOVE <string>,<string>
The first <string> parameter identifies the existing table name, and the
second identifies the new table name.
The following rules apply to frequency dependent offset table names:
a) Table names use a maximum of 12 characters.
b) All characters must be upper or lower case alphabetic characters,
or numeric (0-9), or an underscore (_).
c) No spaces are allowed in the name.
Reviewing Table Data
To review the data stored in a frequency dependent offset table, use the
following commands:
•
MEMory:TABLe:SELect "Offset1"
Select the sensor calibration table named "Offset1".
•
MEMory:TABLe:SELect?
Query command which returns the name of the currently selected
table.
•
MEMory:TABLe:FREQuency:POINTs?
Query command which returns the number of stored frequency
points.
•
MEMory:TABLe:FREQuency?
Query command which returns the frequencies stored in the
frequency dependent offset table (in Hz).
1-44 HP E4418B/E4419B Programming Guide