[Sense[1]]|Sense2:Limit:fail - HP E4418B Programming Manual

[SENSe[1]]|SENSe2:LIMit:FAIL?

This query enters a 1 or 0 into the output buffer indicating whether there
have been any limit failures for the specified channel. A limit failure is
defined as [SENSe[1]]|SENSe2:LIMit:FCO? being non-zero. The FCO
(fail counter) can be zeroed using the
[SENSe[1]]|SENSe2:LIMit:CLEar command.
Syntax
Example
Reset Condition
On reset, the buffer is set to zero for both channels.
HP E4418B/E4419B Programming Guide
• 1 is returned when one or more limit failures have occurred.
• 0 is returned when no limit failures have occurred.
:
SENS
1
SENS2
SENS1:LIM:FAIL?
[SENSe[1]]|SENSe2:LIMit:FAIL?
:
LIM FAIL
This command queries if there
have been any limit failures on
channel A.
SENSe Subsystem
?
9-43